Bathroom and kitchen renovation plumbing
Plumbing for bathroom and kitchen renovations, from moving drains and supply lines to setting the new fixtures.
For your home
Rough-in plumbing for basement bathrooms, wet bars and laundry rooms, including drains below the concrete floor.
Rough-in plumbing is the drain, vent and water lines that go in before the walls, floors and fixtures. Many newer homes already have capped rough-in pipes in the basement floor for a future bathroom, and older homes usually need the concrete opened to add them.
When a new basement fixture sits lower than the sewer pipe leaving your house, the waste has to be pumped up by an ejector pump, a sealed pump in a basin under the floor. Laundry rooms need a drain that can handle the fast discharge from a washing machine, plus hot and cold supply lines with shut-off valves.
We check the existing rough-in, the depth of the main drain and where the new fixtures can tie in.
If the drains have to go under the slab, we cut and remove the concrete along the new pipe route.
We install the new lines with the correct slope and venting, then test them before anything is covered.
The trench is backfilled and the concrete restored, ready for framing and finishing.
Usually they are a rough-in for a future bathroom: a larger pipe for the toilet and smaller ones for the sink and shower. They stay capped until the fixtures are installed.
Only if the fixtures sit below the level of the sewer pipe leaving the house. If gravity can carry the waste out, no pump is needed.
Yes, with a drain and supply lines run to the new spot and a drain pan under the washer to catch leaks. Upstairs laundry needs more care, since a leak there reaches the rooms below.
Based in Kitchener, working across Waterloo, Cambridge, Guelph and Stratford.